All products > Gloves >

PVC Gauntlet Gloves 27cm - Red

Description

The Scan fully coated red PVC gauntlet has a cotton knitted liner that protects against oil, grease and most household chemicals.

They have good resistance to abrasions. The palm and finger surfaces provide excellent grip, and also provide hand and wrist protection.

Good resistance to abrasions
Palm and finger surfaces provide excellent grip
Gives hand and wrist protection
Conforms to EN420 and EN388

EN388 Mechanical hazard
3 = Abrasion 1-4
1 = Blade Cut 1-5
2 = Tear 1-4
1 = Puncture 1-4
X = 2nd Cut A-F

Information

List Price ex.VAT	£3.58
List price inc.VAT	£4.30
Code	SCAGLOGAUN11
Size	L
W x L	130 x 270mm
Qty	1 pair

€ £

Find a Stockist

Certification

View Certificate	EU Declaration of Conformity EN388:2016 + A1:2018, EN 420: 2003+A1: 2009
View Certificate	UK Declaration of Conformity EN388:2016 + A1:2018, EN 420: 2003+A1: 2009

Catalogue page

Scan Catalogue Page 50 pdf

Standard EN ISO 21420

The EN 420 standard was revised in March 2020 becoming standard EN ISO 21420: 2020.

This standard defines the general requirements for protective gloves in terms of construction, fitness of purpose, safety, etc.

Standard EN388:2016

Providing protection for mechanical risks.

This standard applies to all kinds of protective gloves in respect of physical and mechanical aggressions caused by abrasion, blade cut, tearing, puncture and impact.

EN388 Example
3 = Abrasion Rating 1-4
1 = Blade Cut Rating 1-5
2 = Tear Rating 1-4
1 = Puncture Rating 1-4
X = 2nd Cut Rating A-F
P = Impact P Pass or Fail

Protection against mechanical risks is expressed by a pictogram followed by a number rating representing test performance against a specific risk. The performance level is from 1-5, where 4 or 5 is the best result. X = not tested. P = Impact test passed.

The level of performance is based on the number of cycles/force required to penetrate the sample.

Abrasion resistance: based on the number of cycles required to abrade through the sample glove.

Blade cut resistance: based on the number of cycles required to cut through the sample at a constant speed.

Tear resistance: based on the amount of force required to tear the sample.

Puncture resistance: based on the amount of force required to pierce the sample with a standard sized point.

2nd Cut resistance: based on the number of cycles required to cut through the sample.

Impact protection: the area of protection is secured over a domed anvil and is impacted at an impact energy of 5J.