All products > Gloves >

Nitrile Gauntlets with Flock Lining

Description

The Scan Green Nitrile Gauntlets are fully coated with a flock lining for moisture absorption. Gauntlets are food contact approved and offer superior chemical resistance to EN374-2 standard, protecting against oil, grease and most household chemicals. They are also resistant to abrasions and provide excellent grip. The long cuff provides added wrist protection.

Typical application includes, general handling of dilute chemicals, solvents, animal fats, alkalis and petroleum related products and food preparation.

Not recommended for use with concentrated corrosive liquids.

Absorbent flock lining
Food contact approved
Superior chemical resistance
Conforms to EN374-2 and EN388

EN388 Mechanical hazard
3 = Abrasion 1-4
1 = Blade Cut 1-5
0 = Tear 1-4
1 = Puncture 1-4
X = 2nd Cut A-F

Information

List Price ex.VAT	£3.30
List price inc.VAT	£3.96
Code	SCAGLONITG
Size	L
W x L	110 x 330mm
Qty	1 pair

€ £

Find a Stockist

Catalogue page

Scan Catalogue Page 48 pdf

Standard EN ISO 21420

The EN 420 standard was revised in March 2020 becoming standard EN ISO 21420: 2020.

This standard defines the general requirements for protective gloves in terms of construction, fitness of purpose, safety, etc.

Standard EN388:2016

Providing protection for mechanical risks.

This standard applies to all kinds of protective gloves in respect of physical and mechanical aggressions caused by abrasion, blade cut, tearing, puncture and impact.

EN388 Example
3 = Abrasion Rating 1-4
1 = Blade Cut Rating 1-5
0 = Tear Rating 1-4
1 = Puncture Rating 1-4
X = 2nd Cut Rating A-F
P = Impact P Pass or Fail

Protection against mechanical risks is expressed by a pictogram followed by a number rating representing test performance against a specific risk. The performance level is from 1-5, where 4 or 5 is the best result. X = not tested. P = Impact test passed.

The level of performance is based on the number of cycles/force required to penetrate the sample.

Abrasion resistance: based on the number of cycles required to abrade through the sample glove.

Blade cut resistance: based on the number of cycles required to cut through the sample at a constant speed.

Tear resistance: based on the amount of force required to tear the sample.

Puncture resistance: based on the amount of force required to pierce the sample with a standard sized point.

2nd Cut resistance: based on the number of cycles required to cut through the sample.

Impact protection: the area of protection is secured over a domed anvil and is impacted at an impact energy of 5J.